How To Run Cable Through Walls From Basement

Pull the e thernet cable to its destination and you re set.

How to run cable through walls from basement.

Learn how with this video. Have a helper reach into the cavity through the box hole grab the end of the cable and pull it out about 1 foot into the room. For more in depth informatino about running fis. If you can run cable through a basement garage or attic you ll avoid tearing into walls or ceilings.

Finding the best route from the existing cable to the destination. Return to the attic or basement and drill through the wall plate where you want to guide the wire through. You may encounter nails so choose an auger drill bit which won t get damaged by metal. For example in exposed locations such as open basements or attics nm cable usually needs to be run through holes or notches cut in joists rather than stapled to the face of the joists.

If you have another floor to go you can follow the same steps in the same order. Attach the wire or cable to a fish tape or coat hanger using electrical tape and feed it into the hole until it reaches the opening at the other end. Run the wire or cable to its destination. The most important decision of running cable comes first.

Using a hammer and chisel notch a path in the top plate of the wall so that a wire can be run from the wall to the ceiling. Lay down the mounts at least 4ft apart. Hurry to the next floor now and drill a hole in the bottom wall. Make use of the cable mounts to fix the cable along the wall and down to the baseboard.

If your joists are not running the right way then try running the wire in a different wall instead. Run electrical cable through walls and across ceilings without tearing them apart. Drill through on the other side. Connect the cable to the required devices and the work is complete.

Starting from the basement or attic feed the end of non metallic nm electrical cable through the wall plate hole and into the stud bay. From inside the living space position the bit against the wall directly above if accessing from attic or below if accessing from basement the desired location of the service the cable will provide. Mount the cable to the walls of the basement. If you re working from the attic you can drop a weighted string down wall cavity then attach the wire to the string and pull it through.

Use the electric tape to fasten the e thernet wire to your coat hanger and pull it through the wall.